Product usage

1 Use as a disinfectant:
The product is effective against a number of bacteria and fungi. In vitro, it is also effective against Trichophyton interdigitale. First thoroughly clean the surfaces and materials to be disinfected. Then rinse the cleaning agent used in this process with clean water. Remove any excess liquid. If treated surfaces or materials come into contact with food or drink, thorough rinsing with clean water is required after the treatment time has elapsed. Minimum action time: 5 minutes.
For use in places where food and drink are prepared, handled or stored, and for general use, the concentration of use is 8.0 ml per liter of water (1:125). Attention: Use of the product may lead to the selection of bacterial strains that are resistant to it.

2 Fighting green algae
For removing green deposits from windows and materials in empty greenhouses and department stores. Thorough spraying or brushing with a solution of 5% of this product (5 L per 100 liters of water). After a few days, remove dead algae, algae, dirt, etc. by spraying or scrubbing with a hard stream. This cleaning after-treatment does not necessarily need to be carried out in the short term, because this product has no harmful effects or vaporizing effects. For these reasons, treatments can also be carried out as early as a short time before planting.

To prevent green staining on windows and materials in empty greenhouses and department stores. .- Spray on clean windows with a solution of 5% of this product (5 L per 100 liters of water). Due to the absence of harmful effects of this product and the low residual amount, it is not necessary or advisable to re-spray. This method prevents the formation of green deposits for many months. -If windows (e.g. flat glass) are cleaned by hand (by wiping off the water), a solution of 3% (300 mL per 10 liters of water) may suffice.

For removal and prevention of green stains on walls, roofs, tiled paths, flagstones, gravestones, windows, railings, garden furniture, etc. Spray, pour, brush or scrub with a solution of 5% of this product (500 mL per 10 liters of water). Do not rinse. Do not spray or pour on plants.

3. Prevention of bacteria and algae in waterbeds.
To prevent algae and bacteria growth in waterbeds, as well as the turbidity of the water, this product should be added to fresh water at a dosage of 100 mL per 300 L of water (15 ppm active substance). When refilling or replenishing, this product should be added to the water used previously in the same ratio.

Keep pets away from the treated areas as long as they are still moist.
Note: The product becomes ineffective when it comes into contact with soap or synthetic detergents.