Floor Cleaner Power

Mop and bucket method: for normal soiling, use 10 ml product per litre of cold water. If necessary, regularly refresh the water. For heavy soiling, increase the dose up to a maximum of 50 ml product per litre of water.

Stain removal: Use preferably as a pre-treatment. Dose max. 50 ml per litre of water. Spray directly on rubber soiling. Soak for a few minutes and then rinse thoroughly with plenty of clean water. Caution! It does not remove discolouration caused by burnt rubber marks and rubber stripes.

Stripping: use a dosage of 100 ml per litre of water. Apply product using a mop or single-disk machine. Work in areas of 25 m² at a time and let the product act for approx. 20 minutes. In case of heavier soiling, increase the dosage to a maximum of 200 ml per litre of water. Caution! Make sure the product does not dry out. Remove the loosened emulsion with a water vacuum cleaner and rinse the floor once or twice with sufficient clean water and allow the floor to dry thoroughly (pore-deep). Then the new polymer emulsion can be applied if necessary.

After use: Make sure the packaging is empty (drip-free) and return it to your supplier or put it in the plastic waste so that it can be recycled.